| |
Miscellaneous
Hardware and Cable
Interconnecting
Cable -Time Code
We offer the following
cables that are suitable for connecting the time code signal from one
component to another. The cable is shielded RG-58 coax (1/4"-.63cm
diameter) with dual BNC connectors. It is available in the following
lengths:
| Part
Number |
Length |
 |
| CC10 |
10' -
3m |
| CC25 |
25' -
7.6m |
| CC50 |
50' -
17m |
| CC100 |
100'
-30.5m |
Custom lengths can also be supplied - contact factory with requirements.
** Note
that this cable cannot be used with the GPS antenna **
|
|
|
|
BNC Male, 6"/15cm
leads with tinned end
Allows twisted pair wire to be connected to BNC connectors
|
|
RC200
Remote Control - Cable & Adapters
|
RJ12M-RJ12M, 6P6C, 6 Conductor Cable
| Part Number |
Length |
 |
| CCRJ12-50 |
50' / 15m |
| CCRJ12-100 |
100'/30m |
| CCRJ12-250 |
250'/76m |
| CCRJ12-500 |
500'/152m |
|
| DB9F to RJ12F RS485 Cable Adapter for TCD series II clock |
Part Number :
|
CA485 |
|
| RJ12M single port to RJ12F 6P6C multiport adapters, 6 conductor |
Part Number :
|
CARJ12-6C2
|
|
Part
Number :
|
CARJ12-6C5
|
|
Power
Cords
|
| Optional
power cords for analog clocks |
Part
Numbers are:
|
CLKPOWER-US
CLKPOWER-EURO
CLKPOWER-AUS
CLKPOWER-UK
|
|
DB9
& DB 15 to BNC Adapters
|
 |
DB-9 and DB-15 to BNC adapters
allow the inputs and outputs of various Masterclock®
products to be connected via coaxial cable & BNC connectors. Any
type of coaxial cable can be used in this application. The table below
shows where a BNC adapter can be used. Note that these adapters are
normally supplied with the appropriate products however they can also
be purchased seperately.
|
Input Connector |
Output Connector |
Use Adapter |
| GPS200A |
|
DB-9 Male |
BNC9 |
TCI232& TCI232A
TCI500 |
BNC |
DB-9 Male |
BNC9 |
| TCG100 |
|
DB-15 Female |
BNC15 |
| TCR500 |
DB15 Female |
|
BNC15 |
| TCO100 |
DB-9 Male** |
DB-9 Male |
BNC9 |
| **TCO100CC
would normally be used |
|
|
Copyright ©
Masterclock®, Inc. 1994 - 2007 - www.masterclock.com
Last Updated:
June 11, 2008
